Expert Knowledge
10.0 LSA-PLUS® Insertion Tool
with Sensor
Overview
10 - page 4
10.0 LSA-PLUS Insertion Tool
with Sensor
Expert Knowledge
10.0 LSA-PLUS® Insertion Tool
with Sensor
Overview
10 - page 15
Contents of this chapter
10.0 Overview
10.1 Possibilities for use and technical specifications
The LSA-PLUS Insertion Tool S is the central component
for the connection of wires on the KRONE LSA-PLUS /
LSA-PROFIL modules and in applications throughout entire
network topologies.
From the main distribution frame right up to the
subscriber socket, only one single tool is needed.
This chapter describes the function of the insertion tool
and its accessories.
10.1 LSA-PLUS Insertion Tool
with Sensor
Expert Knowledge
10.1 LSA-PLUS® Insertion Tool
with Sensor
Description / technical specifications
10 - page 3
and the hole?
This is where the tool can be attached to the
mounting aid. A handy hook for hanging up the tool
when it is not immediately being used.
Can the scissors be replaced?
No! The hardened, nickel-plated scissors have such a
long service life (refer to technical specifications) that
it is not necessary to replace them. A used tool cannot
be made “as new” simply by replacing the scissors.
Can 0.9 conductor diameters or stranded wires also be
connected?
Depending on the LSA-PLUS series, the tool can be
used to connect all conductors with a nominal
diameter of 0.35mm to 0.9mm conductors; the latter
being common in the field of signalling systems;
stranded-wire cables used in recording studios as well
as solid conductors; thin telecommunication wires as
well as thick, insulated Type 1 data cables.
Two wires in one contact (double connection)?
Most LSA-PLUS series can be connected with 2 wires
(same type, same diameter) for each contact slot. If
you wish to connect a second wire, then the sensor
must be deactivated by moving the clip to the OFF
position.
The LSA-PLUS Insertion Tool with sensor is suitable for
ทั้งหมด 0 ความคิดเห็น
